How Our Injectidry HP60 System Saves Cabinets & Countertops
Using Injectidry HP60 manifold tubing paired with LGR dehumidifiers, we push warm, very dry air through hidden toe-kick ports and behind cabinet backs, drying wet cabinets without removing granite or quartz countertops.
Tearing out lower cabinets means disconnecting plumbing, risking damage to stone countertops, waiting weeks for new cabinets, and living without a working kitchen. When clean Category 1 water is caught early, we follow an in-place cabinet and wall cavity drying process:
Step 1: FLIR Thermal & Deep-Probe Cavity Mapping
We scan the full kitchen or vanity run, including the island, with a FLIR infrared camera and insert insulated deep-wall probes into the toe-kick and back wall cavity to measure moisture in the cabinet base, sides, back drywall, and slab.
Step 2: Hidden Toe-Kick & Baseboard Ports
We gently remove the thin toe-kick trim strip, or drill small ports under the cabinet overhang where they cannot be seen when standing. If water is standing on the slab under the cabinets, we vacuum it out with narrow extraction wands and treat the space with an EPA-registered antimicrobial.
Step 3: Warm, Dry Air Injection (Injectidry HP60)
We run flexible drying tubes from the Injectidry HP60 manifold into every affected toe-kick bay and wall cavity, and feed the manifold with very dry air from a commercial LGR dehumidifier. This pushes a steady stream of warm, dry air under the cabinets and up the back wall, typically drying plywood, wood frames, drywall, and concrete in about 3 to 5 days.